Uploading Boar Pictures for Analysis
Thought for 1 min 8 sec
You want a 1:1 mechanical clone of the board in your photo. I’ve prepared a plan to execute that.
- Steps: collect precise photos/measurements, reconstruct the schematic from images, match parts/BOM, rebuild the single‑sided layout to original geometry, then run checks and export Gerbers/drill/BOM.
- Click Start on the plan bar to proceed.
Before we start, please provide:
- Orthographic top-side photo with a ruler for scale.
- Board width/height and hole locations.
- Potentiometer value/taper and shaft/bushing dimensions.
38mmx45mm
Thought for 1 min 47 sec
You want a 1:1 mechanical clone of this board sized 38 x 45 mm. I’ve prepared a plan and it’s ready to execute.
Steps: capture orthographic photos and dimensions, reconstruct the schematic, identify parts/BOM, rebuild the single‑sided layout, run checks, and generate Gerbers/drill/BOM.
Before we start, please confirm:
- XY coordinates and diameters of both holes (from one corner).
- Value/taper and shaft/bushing sizes of the panel rotary control.
- Board edge interface pin count and pitch (or a straight-on photo with a ruler).
Click Start on the plan bar to begin; you can upload the top-side photo now.
Upload board photos
Provide hole measurements
Specify connector details
Potentiometer specs
Board thickness and copper
Welcome 👋
Flux accelerates your PCB design with AI.
Create your account to start using this component and bring your ideas to life.