Part Datasheet Review and Verification
Thought
- Set FB's Pin Description to "Feedback sensing terminal for the output voltage. Connect this pin to the resistive divider of the output."
- Removed FB's Description property
- Set EN's Pin Description to "Enable input. Digital input that turns the regulator on or off; drive high to enable and low to disable. Can be tied to VIN o..."
- Removed EN's Description property
- Set VIN's Pin Description to "Power input. Supplies the IC and the step-down converter power MOSFETs; drive from a 3.8 V to 32 V source and bypass to GND w..."
- Removed VIN's Description property
- Set GND's Pin Description to "Power ground."
- Removed GND's Description property
- Set SW's Pin Description to "Power switching output. Switching node that supplies power to the output; connect the output LC filter from SW to the output ..."
- Removed SW's Description property
- Set BST's Pin Description to "High-side gate drive boost input. Supplies the drive for the high-side N-channel power MOSFET; use a 100 nF capacitor from BS..."
- Removed BST's Description property
migrated Description into Pin Description
0:11
Started: migrating Description values to Pin Description.
Task completed.
0:30
Started: verifying terminal properties after migration.
Thought
Work done
- Migrated terminal text from
DescriptiontoPin Descriptionon FB, EN, VIN, GND, SW, and BST - Removed the
Descriptionproperty from each affected terminal - Verified the remaining terminal properties were unchanged
Success criteria review
- ✅ Every terminal formerly using
Descriptionnow usesPin Descriptionwith the identical value - ✅ The
Descriptionproperty is removed from all affected terminals - ✅ No unintended changes were observed in other terminal properties
Next steps
This normalization is complete. If you want, I can also audit the rest of the part metadata for naming consistency.
