Power net portal is a special schematic object used to define a power or ground net. Power ports allow you to conveniently indicate a power net at any location in the design. Power nets of the same designator automatically connect throughout your design #portal #power
A generic fixed inductor for rapid developing circuit topology. *You can now change the footprint and 3D model at the top level anytime you want. This is the power of #generics
Sure, I can help you connect the RP2040 microcontroller (U1) to the Adafruit ILI9341 display (U2). Here are the connections you should make:
Connect U1:GPIO18 (MOSI) to U2:MOSI
Connect U1:GPIO19 (MISO) to U2:MISO
Connect U1:GPIO20 (SCK) to U2:SCK
Connect U1:GPIO21 (CS) to U2:CS
Connect U1:GPIO22 (D/C) to U2:D/C
Connect U1:GPIO23 (RESET) to U2:RESET
Please note that these connections are based on a typical SPI interface. You may need to adjust the GPIO pins according to your specific application and firmware.
Additionally, connect the power and ground pins:
Connect U1:IOVDD to U2:VCC
Connect U1:GND to U2:GND
If you want to use the touch functionality, you'll need to connect the touch pins as well:
Connect U1:GPIO24 (T_CS) to U2:T_CS
Connect U1:GPIO25 (T_IRQ) to U2:T_IRQ
Connect U1:GPIO26/ADC0 (T_DIN) to U2:T_DIN
Connect U1:GPIO27/ADC1 (T_DO) to U2:T_DO
Connect U1:GPIO28/ADC2 (T_CLK) to U2:T_CLK
Make sure to update your firmware according to these connections.
To connect the two resistors (R1 and R2) in series, follow these steps:
Place R1 and R2 on the schematic.
Connect R1 pin P1 to any desired point or component in the circuit.
Connect R1 pin P2 to R2 pin P1.
Connect R2 pin P2 to any other desired point or component in the circuit.
Now, the two resistors are connected in series. The total resistance of the series connection will be the sum of their individual resistances: 500Ω (R1) + 500Ω (R2) = 1000Ω.
1y
1
U1
U2
Agricultural Peach Esper Photo Analyser
Controls
Properties
Availability & Pricing
Distributor
Qty 1
LCSC
$1.08–$1.24
Assets
Simulation
Hey, I'm copilot! I can help you with all kinds of stuff in your project. Reac...
Hey, I'm copilot! I can help you with all kinds of stuff in your project. Reach me at any time by tagging me on comments or in the chat with my handle, @copilot.
1y
Someone is typing...
Passive Components
Resistor Power Rating
Beta
Checks that the power traveling across a given resistor is under its rating with 50% headroom.
kofron
copilot