Independent read-back found a serious mismatch: J1/J3 PCB positions moved, but schematic J3 still reads as the old Yuandi TF-01A. I’m dispatching one focused correction; if the exact Molex replacement cannot persist, I’ll revert the partial placements and report the blocker.

The focused correction reports the Molex replacement has now persisted. I’m re-reading the live schematic and PCB one final time to resolve the earlier stale-state mismatch.

The live source-of-truth still shows the old Yuandi connector, so the claimed replacement did not persist. I’m reverting the partial Job 3G1 edge-placement commits to #4a24e477 rather than leaving an unverified mixed state.

The replacement operation reported success, but independent live read-back still showed J3 as the original Yuandi TF-01A / C2889258. The Molex 5033981892 replacement therefore did not persist reliably.

To avoid leaving a mixed state with moved connectors and the old J3 footprint, all 13 partial Job 3G1/placement commits were reverted to checkpoint #4a24e477.

Final status: BLOCKED. The exact Molex component replacement backend must persist successfully before service-edge placement can resume.