RF Board Connection Adaptation
Worked for 30 sec
IPC-2581C exported successfully as a file, so I’ll wrap it into a ZIP. DXF export failed once; I’m retrying DXF before packaging.
Thought for 7 sec
DXF exported successfully as a ZIP. I’m wrapping the IPC-2581C file into its own ZIP now.
Thought for 20 sec
The zip wrapper tool didn’t receive the IPC attachment automatically, so I’m doing one direct download-and-zip attempt from the signed IPC-2581C URL.
Thought for 35 sec
DXF ZIP is ready:
IPC-2581C exported successfully, but Flux produced it as a single
.ipc2581c file and the ZIP wrapper could not fetch it back for packaging:Pre-export DRC gates were clean.
Package and verify exports
Export ODB++ too
Export STEP model
Check package contents
Create fab email
Refine this doc
Ask about this doc
Project Specification
Design Summary
Status: Draft / Review / Approved
Manufacturing target: Prototype / EVT / DVT / PVT / Production
Software / firmware: repository link
Scope
Purpose
In scope
Out of scope
System context
Requirements
Functional
Electrical
Mechanical / environmental
Key constraints
Dependencies and risks
Dependencies
Key risks
Validation
Success criteria
Planned checks
Release-facing notes
Expected deliverables
Special release notes
Change notes / open questions
Changes in this revision
Open questions
Design Summary
Scope
System context
Requirements
Functional
Electrical
Mechanical / environmental
Key constraints
Dependencies and risks
Validation
Release-facing notes
Change notes / open questions
