Blinking LED Circuit Design


  • Set Trace's layer to "Bottom Copper"
  • Set Trace's layer to "Bottom Copper"
  • Set Trace's layer to "Bottom Copper"
  • Set Trace's layer to "Bottom Copper"
Update the layer of traces on net VBAT_RAW to Bottom Copper
Updated 4 existing VBAT_RAW trace segments to Bottom Copper.
  • Set Trace's layer to "Bottom Copper"
  • Set Trace's layer to "Bottom Copper"
  • Set Trace's layer to "Bottom Copper"
  • Set Trace's layer to "Bottom Copper"
i want you to update placement of J1 in the same location as SW1 and flip it's side to avoid overlap of the two
Moved J1 to SW1’s exact PCB position and flipped J1 to the Bottom side to avoid top-side overlap. Post-check shows no overlapping copper errors, with 14 airwires still remaining overall.
Check J1/SW1 DRC
Route J1 airwires
Show placements
Verify connector clearance
  • Set J1's position to "-3.6616mm -26.9586mm"
  • Set J1's layer to "Bottom"

No schematic drawn yet

Your and are available in the table tabs. Ask Flux to draw the schematic, or draw it yourself.

Project Specification — 555 LED Blinker
Goal
Design a simple through-hole timer circuit that blinks a red LED once per second from a 9V PP3/block battery through an on/off switch.
Architecture

Diagram


9V battery connector J1 On off switch SW1 Switched node_9V rail NE555P astable timer U1 680 ohm current limit R3 5mm red LED LED1 GND 100nF decoupling C2 and node_10uF bulk C4 47k R1 plus node_47k R2 plus node_10uF C1 timing network 10nF control bypass C3
Selected values
  • U1: NE555P, DIP-8 through-hole timer.
  • J1: Keystone 967 9V battery snap connector.
  • SW1: SPST maintained on/off switch in series with battery positive.
  • R1 = 47kΩ, R2 = 47kΩ, C1 = 10uF for astable timing.
  • Calculated frequency: f = 1.44 / ((R1 + 2R2) x C1) = about 1.02Hz.
  • R3 = 680Ω for approximately 10mA red LED current from 9V, allowing for LED forward voltage and 555 output drop.
  • C2 = 100nF VCC decoupling, C3 = 10nF control pin bypass, C4 = 10uF bulk input capacitance.
Hand-soldering notes
All selected components are through-hole or hand-solder-friendly: DIP-8 IC, axial resistors, radial/disc capacitors, through-hole/panel switch, battery connector, and 5mm LED.
  • Goal

  • Architecture

  • Selected values

  • Hand-soldering notes