Confirmed: the current 10-pad footprint is correct, and no ANT pad should be added.
Official drawing specifies 10 pads: M0, M1, RXD, TXD, AUX, VCC, GND, plus three fixed holes connected to GND.
The antenna interface is an on-module SMA-K connector, 50 Ω, not a host-PCB terminal.
The 21 × 36 mm DIP body, 1×7 header at 2.54 mm pitch, rear three-hole pattern, and SMA outline agree with the documentation.
A valid official Ebyte datasheet URL is already populated, so no Datasheet property update was needed.
Remaining metadata mismatches: all terminal types/descriptions are currently unspecified, pins 8–10 are not explicitly described as GND in their properties, Mount = Wire is questionable, and the 3D asset is named E220-900T22D rather than E22-900T22D.
I’ll correct the datasheet-backed terminal metadata while preserving the verified 10-pad footprint and omitting any ANT terminal. I’ll also re-check the package/mount metadata and verify the result afterward.
The 10 terminals now have datasheet-correct electrical types and concise pin descriptions; pins 8–10 are explicitly identified as grounded fixed holes. I’m doing the final symbol and part-review verification now.
Footprint geometry remains unchanged: seven 2.54 mm-pitch interface pins plus three grounded fixed-hole pads, with no ANT pad. The antenna remains represented as the module’s onboard SMA interface.