• Project already has a Datasheet URL set: https://www.jae.com/direct/topics/topics_file_download/topics_id=66512&ext_no=06&_lang=en&v=
• Because the URL is already set, I did not update the Datasheet URL property.
• Official JAE product page found: https://www.jae.com/connectors/series/detail/product/id%3D66512
• Official alternate product page found: https://products.jae.com/gl/en/connectors/category/io/dx07-receptacle/dx07s024wj1r350/

• The 24 USB Type-C contacts A1–A12 and B1–B12 are all represented.
• The symbol also includes six mechanical mounting terminals MH1–MH6.
• No extra electrical USB-C contacts were found beyond the expected 24.
• Primary mismatch: every terminal currently has Pin Type: Unspecified. Recommended terminal pin types:
  • GND_1/GND_2/GND_3/GND_4: Ground
  • VBUS_1/VBUS_2/VBUS_3/VBUS_4: Power In or Passive depending how the connector is intended to be reused; for a connector library part, Passive is often safer, but Power In gives better ERC semantics when used as a USB receptacle.
  • D+/D-, TX/RX, CC, SBU: Passive or Bi-Directional; for a connector library symbol, Passive is usually least intrusive.
  • MH1–MH6: Ground if shell/ground plate is intended to connect to shield/ground, otherwise Passive.
• Recommended add Pin Description properties for all terminals using concise descriptions such as Ground, VBUS power, USB2 D+, USB2 D-, CC channel, Sideband use, SuperSpeed TX+, etc.

• DX07S024WJ1R350.kicad_mod marked as footprint.
• DX07S024WJ1R350.stp marked as 3D model.
• DX07S024WJ1R350 Symbol.svg marked as default symbol and thumbnail.

• One footprint node.
• Pads for all 24 schematic terminals A/B contacts, named by signal terminal designator.
• Pads for MH1–MH6 corresponding to the schematic mechanical terminals.
• Additional footprint-only mount pads MH7 and MH8 appear in the layout under the Mounts container but do not appear as schematic terminals.

• The footprint appears to include all 24 electrical contacts plus six schematic-exposed mounting pads.
• Potential mismatch: layout has additional mount pads MH7 and MH8 that are not represented as schematic terminals. This may be acceptable if they are non-electrical footprint-only mechanical pads, but it should be checked against the official drawing. If these are conductive shell/ground tabs, consider adding corresponding terminals or ensuring they are intentionally tied/handled in the footprint.
• I could not fully extract pad dimensions from the drawing PDF because the file extraction timed out. Footprint geometry should be visually/mechanically verified against JAE’s official drawing before release.

1. Add/update project properties:
   • Package or Case Code: USB Type-C vertical receptacle, 24-position, 2-row SMT
   • Operating Voltage: 48 V
   • Max Current: 5 A
   • Operating Temperature: -40°C to +85°C
2. Update all terminal Pin Type values from Unspecified to appropriate connector-safe types.
3. Add Pin Description properties for every terminal.
4. Verify whether footprint-only MH7 and MH8 should be exposed as terminals or left mechanical-only.
5. Verify the footprint pad dimensions against JAE’s official drawing/land pattern before publishing/using in production.