LED3
LED2
LED1
R1
Resistance
150 Ω
P4-Rt-Neg
P2-Rt-Pos
P1-Lt-Pos
P3-Lt-Neg

3 LED 12v parallel sub-layout (manual position)

3 LED 12v parallel sub-layout (manual position)
Description

Created
Last updated by cdrxander
1 Contributor(s)
cdrxander

Controls

Properties

Designator Prefix
LED-SEG-

Availability & Pricing

DistributorQty 1

Assets

    Simulation

    µs

    Simulation Speed

    Welcome to the all-new Copilot

    Use Copilot to brainstorm projects, search the library, place and connect components, and more. Click a prompt or write your own to get started. Learn More

    Explain
    Write Project Description
    Find Issues
    Test Plan
    Recommend Similar Parts
    Flux Copilot Video TutorialPlay Video
    Checks that the power traveling across a given resistor is under its rating with 50% headroom.
    Learn more
    Checks that IC pins that require pull up or pull down resistors have them.
    Learn more
    Checks that capacitors have appropriate voltage ratings to prevent overheating and ensure reliable circuit operation.
    Checks that all parts have a part number and are available from distributors.
    Reports issues with Auto-Layout if Copilot cannot route something or must ignore a configuration.
    Reports parts that have no footprint.
    Reports nodes that are assigned to a layer that doesn't exist in the layout stackup.
    Reports components that have been modified using the "!important" flag.
    Reports terminals that are not connected properly. NOTE: Only connections to the center of pads are considered valid.
    Reports nodes that are using rules that are not supported anymore.
    Reports layers that have multiple copper fills of different nets. Make sure the Connected Layers rule value of nets with fills is valid.