ESP32 Smart City Controller
Worked for 8 mins 15 sec
Created 11 project docs
Project Specification — ESP32 Smart City Controller
Status: Review ESP32 DevKitC 38-pin carrier PCB for a smart-city demonstration with distance sensing, servo actuation, sound/sensitivity ana...
Power Budget — ESP32 Smart City Controller
| Rail | Load | Typical | Peak / Design Case | Basis | |---|---|---:|---:|---|
Firmware Starter — ESP32 DevKitC
MCU board: ESP32 DevKitC 38-pin / esp32dev Framework: Arduino
Board Bring-Up Plan — ESP32 Smart City Controller
Current-limited 5 V bench supply, multimeter, oscilloscope, USB cable, known HC-SR04, known servo, microphone module, 10 kΩ potentiometer, a...
Show 7 More
Created and verified the complete ESP32 Smart City Controller schematic, including HC-SR04 level shifting, servo stabilization, analog inputs, and six LED channels. Documentation: Project Specification, Power Budget, Firmware Starter, and Bring-Up Plan.
- Open item: ERC reports
U1:VPas an unpowered supply due to an incorrect library pin classification; VP is actually unused GPIO36 and is correctly marked no-connect. - Next: confirm the servo model/stall current, then configure the board and place components with antenna keepout and wide 5 V/ground paths.
Thought for 7 sec
Claro — necesito que me indiques cuál capacitor y dónde debería ir.
Puedes responder con algo como:
- “C1 debe ir junto al conector del servo J3”
- “C3 debe ir cerca del pin 5V del ESP32”
- “El capacitor cerca de la esquina inferior derecha debe ir junto a U1”
Si puedes, selecciona el capacitor en Flux o dime su designador (C1, C2, C3, C4 o C5) y lo muevo a su lugar.
Thought for 6 sec
Perfecto, revisaré el componente seleccionado y lo recolocaré donde corresponde según su función en el circuito.
Worked for 7 mins 33 sec
Listo. Moví C1 junto al conector del servo J3, manteniendo el resto de los componentes en sus posiciones. Verifiqué que quedó dentro de la placa y sin solapamientos.
Revisar, enrutar y verificar
Revisar colocación completa
Enrutar placa
Ejecutar DRC
Revisar polaridad
