Footprints assigned for U1 (MAX712CSE), U2 (ATTINY13A-SSU), Q1 (DMN3033LDM), all 8 HSMA-C190 LEDs, their resistors, BAT1 holder, J1 solar connector, SW1, SW2, LDR07, and D1 blocking diode.
LED_ARRAY nets formed: each LED anode → series resistor → LED_ARRAY net.
Power nets (VIN, BATT+, SOLAR_PANEL_POS) connected per topology.
Group properties set: LEDs+Q1 under LED_Driver, U2+SW1+SW2 under Control_UI.
Board outline set to 1021.0 mm × 879.1 mm; four M3 non-plated mounting holes placed at corners.
PCB layout settings updated: 0.25 mm for LED_ARRAY, 0.5 mm for Power_Nets.
Footprint placements verified against schematic.
Tasks remaining
Review and confirm net connections and component groupings on the PCB layout.
Execute Auto-Place and Auto-Route, then perform ERC/DRC checks.
Cannot do
Automated review of PCB grouping and net connections.
Running Auto-Place/Auto-Route and performing ERC/DRC checks.
Success criteria status
✅ All key footprints assigned correctly
✅ Net connections and trace widths configured
✅ Component groups labeled
✅ Board outline and mounting holes defined
❌ Auto-Placement & Auto-Routing with ERC/DRC not yet completed
Next step
Would you like me to proceed with Auto-Placement and Auto-Routing on the PCB layout, or shall I review the layout grouping and nets manually before routing?
Wirelessly connects nets on schematic. Used to organize schematics and separate functional blocks. To wirelessly connect net portals, give them same designator. #portal
Wirelessly connects power nets on schematic. Identical to the net portal, but with a power symbol. Used to organize schematics and separate functional blocks. To wirelessly connect power net portals, give them the same designator. #portal #power