Part Review and Datasheet Update
Thought for 2 mins 5 sec
I reviewed the part project and compared it to the official TI datasheet. The audit followed the standard part-project datasheet-sync workflow: verify metadata first, then compare terminal definitions and footprint pad coverage against the datasheet pin table
What I found
Metadata status
Table
| Field | Current / Observed | Datasheet | Status |
|---|---|---|---|
| MPN | TPS543021DRLR | TPS543021DRLR | Match |
| Manufacturer | Texas Instruments | Texas Instruments | Match |
| Datasheet URL | Already set to TI official PDF | Official TI PDF | Match, no URL update needed |
| Package / case | Was SOT-5X3 (DRL) after correction | DRL, SOT-563 / SOT-5X3, 6 pins, 1.6 mm x 1.6 mm | Match |
| Part type | Was Buck Converter after correction | 4.5 V to 28 V, 3 A synchronous step-down converter | Match |
| Pin count | 6 | 6 | Match |
| Description | Present, but wording said wide input voltage and 3 A | Datasheet confirms 4.5 V to 28 V, 3 A synchronous buck | Mostly match |
Table
| Spec | Value |
|---|---|
| Function | Synchronous step-down converter |
| Input voltage range | 4.5 V to 28 V |
| Output current | Up to 3 A |
| Switching frequency | 400 kHz typ |
| Operating temperature | -40 C to 150 C junction |
| Package | DRL / SOT-563 / SOT-5X3 |
| Package size | 1.6 mm x 1.6 mm |
The schematic symbol has all 6 required terminals, and the pin numbers match the datasheet exactly.
Pin map check
Table
Table
| Check | Result |
|---|---|
| Pad count | 6 / 6 correct |
| Pad naming coverage | Correct |
| Package family alignment | Consistent with DRL 6-pin package |
| Detailed geometry verification | Not fully provable from the current layout data alone |
Table
| Item | Finding | Severity |
|---|---|---|
| Pin Type properties | All terminals are currently Unspecified instead of mapped from the datasheet | Medium |
| Pin descriptions | No per-pin description properties are populated | Medium |
| Package metadata | Package field was inconsistent before correction | Fixed |
| Part type metadata | Needed normalization to Buck Converter | Fixed |
| Footprint geometry dimensions | Pad existence is correct, but exact land pattern dimensions were not exposed by the project data I can read here | Review manually if you want full package-land-pattern validation |
Based on the datasheet pin functions, these should be the terminal types:
Table
- The official datasheet URL was already present, so no datasheet-URL update was needed.
- The symbol is structurally correct: all 6 pins exist and match the datasheet numbering.
- The footprint appears complete at the pad-count/name level.
- The biggest remaining issues are metadata completeness on the terminals:
- pin types are unset
- pin descriptions are missing
- I also corrected the project metadata for Package or Case Code and Part Type to match the datasheet.
Fix flagged mismatches
Prioritize critical parts
Use official datasheets
Check footprint accuracy
Thought for 3 sec
- Set Package or Case Code to "SOT-5X3 (DRL)"
- Set Part Type to "Buck Converter"
