220 Ohms ±5% 0.25W, 1/4W Through Hole Resistor Axial Automotive AEC-Q200 Carbon Film
This component is a fixed-value carbon film resistor intended for general-purpose electronic circuits. It is designed to provide stable resistance with reliable performance under typical operating conditions. The resistor is suitable for applications requiring moderate precision and dependable thermal characteristics, making it appropriate for use in consumer electronics, control circuits, and signal conditioning. Its construction ensures consistent electrical behavior, good noise performance, and durability over time.
Electrical Characteristics
The nominal resistance value is two hundred twenty ohms.
Tolerance is within a standard general-purpose range, suitable for non-critical precision applications.
The resistor exhibits stable performance across typical ambient temperature variations, with predictable resistance drift characteristics inherent to carbon film technology.
Power Rating
The device is rated for low-power dissipation applications, consistent with standard small-form-factor through-hole resistors used in printed circuit board assemblies.
Construction and Materials
The resistor element is formed from a deposited carbon film on a ceramic substrate, providing a balance between cost, stability, and noise performance. Leads are axial and suitable for through-hole mounting. The body is coated for insulation and environmental protection.
Environmental and Reliability Considerations
The component is designed to operate reliably under standard environmental conditions, including moderate temperature and humidity ranges. It demonstrates acceptable long-term stability for general electronic use, with resistance changes remaining within specified tolerance limits over time.
Applications
Suitable for voltage division, current limiting, biasing, and general signal conditioning in analog and digital circuits where high precision is not critical.
