I'm sorry but your project doesn't seem to include a component or pin labeled as "VCC". The project has VC* designators ranging from VC0 to VC16, but no "VCC". Could you mean one of these, or perhaps a different component?

To help me understand your requirement better, could you please specify the component and the pin you're referring to?

For example, if you want to connect the "VC0" pin to the 5V supply, the connection would look something like this:

Note: Please ensure the operating voltage of your components is compatible with a 5V supply to avoid any potential damage.

I noticed that TP6 is not listed in the project description you provided. However, you want to connect the "DSG" pin to it. Assuming that TP6 is an accessible test point on your PCB, here's how you'd typically make that connection:

Please note that without more information, I can't determine the specific routing requirements for your board, like width and layer. Also, TP6 may or may not need to be setup as a net depending on your circuit's needs.

Please note this advice may not suit your specific needs, constraints or the specifications of your components. Therefore, it's crucial to check the datasheets of your components and validate your design with simulations and measurements.