Add MH Pins
Thought for 4 sec
I’ll verify the connector datasheet/mechanical drawing for the mounting holes, then add MH1–MH4 pins to the part and check the result.
Worked for 1 min 40 sec
The datasheet confirms a 9-position connector with four 0.6 mm mounting features in the recommended hole pattern; the PCB footprint already has MH1–MH4 pads, so I’m adding the matching schematic/part pins now.
Worked for 1 min 38 sec
Added the four mounting-hole pins MH1–MH4 as passive terminal pins and verified they match the existing MH1–MH4 footprint pads.
Open items:
- The datasheet OCR confirms the recommended hole pattern includes 4× 0.6 mm mounting features, but critical mechanical values should still be visually checked against the PDF if this footprint is going to production.
Suggested next steps:
- Run a full part review/check pass.
- Verify the MH pads are tied to shield/ground if that’s intended for your library convention.
- Publish/update the part once reviewed.
Review, ground, export
Run part review
Ground MH pads
Verify datasheet footprint
Export updated part
