Part Information Review and Datasheet Validation
Add the correct pin descriptions and pin types from the Molex datasheet.
Thought for 5 sec
I’ll update the four connector terminals with datasheet-appropriate contact descriptions and passive connector pin types, then verify the terminal properties.
Worked for 3 mins 8 sec
Done — pins 1–4 now each have a passive pin type and a Molex contact-based description matching the 4-circuit Micro-Fit+ wire-to-board header.
Open items:
- Flux warned that “Contacts” is not a standard Pin Group value, but it was applied successfully and is appropriate for this connector.
Suggested next steps:
- Run part review checks for terminal properties.
- Verify/rebuild the footprint pads if the project still reports zero pads.
- Confirm whether you want shorter pin descriptions for library display.
Run checks, fix footprint
Run part checks
Verify footprint pads
Shorten pin descriptions
Check pad mapping
