LED Blinking Circuit Design
Thought for 30 sec
I couldn’t find Flux documentation for saving/downloading a schematic screenshot, so that specific feature is probably not available in Flux. You can browse the docs here: Flux Documentation.
How do I export the schematic instead of taking a screenshot?
Thought for 19 sec
Flux exports are mainly for PCB/layout files, not a schematic drawing: the export tool supports PDF/SVG/DXF and manufacturing outputs, but the docs note that all export types generate from PCB layout data and none export schematics . For your schematic, the practical options are to use your computer’s screenshot/print-to-PDF tools, or make the actual PCB layout first and then export PDF/SVG/Gerbers from the layout.
is there a tool to fix wiring
Thought for 15 sec
Yes — I can help fix schematic wiring by inspecting the nets, making/removing pin connections, and then checking ERC results; the wiring tool uses exact pin IDs like
U1:VCC and net names like ^GND . If you want, tell me what is currently wrong or which part you want connected, and I can check the schematic and fix the wiring for you.Fix wiring issues
Run ERC check
Wiring tool help
Check power nets
Refine this doc
Ask about this doc
Design Notes — 9V NE555 LED Blinker
Requirements
- 9V block battery input through an on/off switch.
- NE555 astable oscillator to blink a red LED once per second.
- Hand-solderable component choices: DIP-8 IC, through-hole battery holder, switch, 5mm LED, axial resistors, radial/disc capacitors.
555 astable timing calculation
Using standard NE555 astable equation:
- Period: T = 0.693 × (RA + 2RB) × C
- Frequency: f = 1 / T
Selected values:
- RA = R1 = 4.7kΩ
- RB = R2 = 4.7kΩ
- C = C1 = 100uF
Calculation:
- T = 0.693 × (4.7kΩ + 2 × 4.7kΩ) × 100uF
- T ≈ 0.977 s
- f ≈ 1.02 Hz
This is within practical tolerance for a “once per second” visual LED blink. Electrolytic capacitor tolerance will dominate real-world timing.
LED current calculation
Selected R3 = 1kΩ for a red LED from the 9V 555 output.
Approximate current:
- I ≈ (9V − 2V) / 1kΩ ≈ 7 mA
This is bright enough for an indicator LED while conserving a 9V battery.
Support components
- C2 = 100nF from VCC to GND for NE555 supply decoupling.
- C3 = 10nF from CONT to GND for NE555 control voltage noise filtering.
Connectivity summary
- Battery positive goes through SW1 to the switched 9V rail.
- U1 RESET is tied to switched 9V so the timer runs when powered.
- R1, R2, and C1 form the astable timing network.
- U1 OUT drives D1 through R3.
Requirements
555 astable timing calculation
LED current calculation
Support components
Connectivity summary
