MIDI Device Build
Thought for 24 sec
Thought for 14 sec
Read shop.pimoroni.com.
no amke an aequilivent, use sthat as example
Thought for 12 sec
flux
Understood—I’ll use the Pico Plus 2 only as the reference architecture, not as a module. The custom board will use a bare RP2350B with 16 MB QSPI flash, 8 MB PSRAM, USB-C, and the required RP2350 power/clock/boot circuitry, integrated with the MIDI and battery sections.
Thought for 11 mins 16 sec
Thought for 13 sec
Thought for 9 sec
Awaiting 1 background task
"Bare RP2350B Schematic" completed.
Thought for 11 sec
flux
The design direction was corrected to a custom bare RP2350B board equivalent to the Pico Plus 2 architecture, with 16 MB QSPI flash, 8 MB PSRAM, USB-C, BQ24074 power-path charging, TPS63031 power conversion, MIDI I/O, buttons, OLED, and battery monitoring. Forty-two schematic components have been selected and added.
Open items
- The schematic is not yet wired; the project currently reports 0 nets.
- Verify the completed component selection and remove any remnants of the abandoned module-based approach.
- Arrange and wire every functional block.
- Update the Project Specification and project description from Pico 2 module to bare RP2350B.
- Run ERC and an independent electrical review.
- Create the firmware pin map and board bring-up plan.
- PCB layout has not started.
Execution stopped because your ACUs ran out.
