Adjusting RV1 Potentiometer
CHANGE RV1 PY POTENTIAL METER
Thought for 9 sec
I’ll update RV1’s potentiometer setting in-place if it’s just a value/property change; first I’ll inspect RV1 to confirm its current part and editable properties, then apply the change and verify it.
Thought for 26 sec
RV1 is already a through-hole Bourns 3386P vertical potentiometer/trimmer, wired for base bias. I don’t need to replace it because replacing would risk breaking its existing connections; I’m just verifying the current state now.
Thought for 43 sec
RV1 is already a 10k through-hole potentiometer/trimmer: Bourns 3386P-1-103LF. I verified it is wired correctly for base bias: pin 3 to 12V, pins 1 and 2 tied to the BASE_BIAS node, so no replacement was needed.
Use panel-mount pot
Find smaller trimmer
Check RV1 footprint
Verify RV1 design
Refine this doc
Ask about this doc
Project Specification
Design Summary
Status: Draft / Review / Approved
Manufacturing target: Prototype / EVT / DVT / PVT / Production
Software / firmware: repository link
Scope
Purpose
In scope
Out of scope
System context
Requirements
Functional
Electrical
Mechanical / environmental
Key constraints
Dependencies and risks
Dependencies
Key risks
Validation
Success criteria
Planned checks
Release-facing notes
Expected deliverables
Special release notes
Change notes / open questions
Changes in this revision
Open questions
Design Summary
Scope
System context
Requirements
Functional
Electrical
Mechanical / environmental
Key constraints
Dependencies and risks
Validation
Release-facing notes
Change notes / open questions
