SHT41 Temp Sensor Search
Thought for 46 sec
You were right - I’ve now actually labeled the schematic nets so the wiring around the motor driver is named instead of just implied. Renaming net designators is the correct project edit for adding wire labels in the schematic
Added schematic labels
Table
| Net label | Meaning |
|---|---|
DRV_VCC1_3V3 | TT Motor logic supply from Rpi1 3V3 |
DRV_VCC2_5V | TT Motor motor supply from Rpi1 VBUS |
DRV_IN1_GP2 | TT Motor IN1 from Rpi1 GP2 |
DRV_IN2_GP3 | TT Motor IN2 from Rpi1 GP3 |
DRV_EN12_GP4 | TT Motor EN12 from Rpi1 GP4 |
I2C_SDA_GP0 | sensor SDA bus from Rpi1 GP0 |
I2C_SCL_GP1 | sensor SCL bus from Rpi1 GP1 |
SERVO_PWM_GP5 | servo control from Rpi1 GP5 |
LIMIT1_GP6 | Limit Switch 1 signal |
LIMIT2_GP7 | Limit Switch 2 signal |
If you want, I can do one more cleanup pass and rename them to match the picture even more closely, like:
AIN1AIN2PWMAMOTOR_5VLOGIC_3V3
Rename to motor style
Label limit nets
Check pull resistors
Run ERC review
Thought for 2 sec
- Renamed 3V3_SENSORS to DRV_VCC1_3V3
- Renamed VBUS_5V to DRV_VCC2_5V
- Renamed MOTOR_IN1 to DRV_IN1_GP2
- Renamed MOTOR_IN2 to DRV_IN2_GP3
- Renamed MOTOR_PWM to DRV_EN12_GP4
- Renamed SERVO_PWM to SERVO_PWM_GP5
- Renamed LIMIT_DEPLOYED to LIMIT1_GP6
- Renamed LIMIT_RETRACTED to LIMIT2_GP7
- Renamed I2C_SDA to I2C_SDA_GP0
- Renamed I2C_SCL to I2C_SCL_GP1
![Raspberry Pi Pico | End-to-end AI Design Tutorial [Example] thumbnail](https://img-cdn.flux.ai/eyJidWNrZXQiOiJncmF2aXRvbi1lbGVjdHJpYy1zeW1ib2xzIiwia2V5IjoiZG9jdW1lbnRfYXNzZXRzL1RodW1ibmFpbC1ScGljby0tMS0tM2QwMGFjNzYtZjEzNi00YTkzLWJjYTEtYTlkZjc0ZGI0NmE3LnBuZyIsImVkaXRzIjp7InJlc2l6ZSI6eyJ3aWR0aCI6MTM2LCJoZWlnaHQiOjEzNiwiZml0IjoiY29udGFpbiIsImJhY2tncm91bmQiOnsiciI6MCwiZyI6MCwiYiI6MCwiYWxwaGEiOjB9fX0sIm91dHB1dEZvcm1hdCI6IndlYnAifQ==)
