Adding an LED to Circuit
Thinking for 20 days...
add a led
Thought for 2 sec
I’m blocked from editing the project right now because this session has no remaining execution credits. Also, your current access level is comment, so project edits may require owner/edit access.
What remains to add an LED:
- Confirm what kind of LED you want:
- simple status LED, or
- another WS2812/addressable LED.
- Choose where it connects:
- power indicator across 3.3 V or 5 V, or
- GPIO-controlled indicator from the ESP32.
- Add the LED plus the correct current-limiting resistor if it is a standard LED.
- Wire it into the schematic and run review checks for ERC issues.
Recommended default if you want a basic indicator: add a standard green LED + 1 kΩ resistor from 3.3 V to GND as a power/status LED.
Green power LED
GPIO status LED
Manual add steps
Run ERC check
