Chat

Welcome to Flux

Treat Flux like your intern. Tell it what you'd like to build and it'll get to work. You can also ask it questions, brainstorm ideas, and teach it your preferences. Learn More

Explain project
Write a project description
Find schematic issues
Create a test plan
Simulate a circuit
Prepare for Manufacturing
Component Selection Workflow
New Subsystem Wizard
Sign up to send
what is the resistance of R1 and R2 needed to protect IO?
vasyl

vasyl

@copilot what is the resistance of R1 and R2 needed to protect IO?
2y

copilot

To determine the resistance value of R1 and R2 for IO protection, several factors need to be considered, including:
  • The maximum permissible current for the IO pin.
  • The voltage level of the IO signal.
  • The type of signal line (digital or analog).
The basic formula for calculating the resistance value is Ohm's Law:
R = V/I
where R is the resistance, V is the voltage across the resistor, and I is the current through the resistor.
However, without the specific details about the IO pin and its characteristics, I cannot provide a precise resistance value. Could you provide more details about the IO specifications, such as the maximum permissible current and the voltage level of the IO signal line?
2y
vasyl

vasyl

can you help me with values for C7,C6,R4,R5 and C5?
2y

copilot

The values for C7, C6, R4, R5, and C5 depend on the specific requirements of your circuit, such as the frequency of operation, the need for filtering, and the impedance levels.
However, here are some general guidelines:
  1. C7 and C6: These capacitors are typically used for decoupling and filtering. A common value is 0.1µF, but this can vary depending on the specific needs of your circuit.
  2. R4 and R5: The resistance value depends on the current you want to allow through the circuit. A common value might be 10kΩ, but this can vary widely.
  3. C5: This capacitor's value would also depend on the specific needs of your circuit. A common value might be 1µF, but this can also vary.
Keep in mind that these are general suggestions and the actual values should be determined based on the specific requirements of your circuit. You should also consider the tolerances and voltage ratings of these components when choosing them.
2y
Someone is typing...
2
C2
Capacitance
10uF
C5
Capacitance
1uF
D
C6
Capacitance
0.1uF
C3
Capacitance
0.1uF
R
C7
Capacitance
0.1uF
D
C4
Capacitance
0.1uF
R
C1
Capacitance
1uF
R4
Resistance
60 Ω
R2
Resistance
120 Ω
D1
End of Life
IC1
R5
Resistance
60 Ω
RS
R1
Resistance
120 Ω
VCC
R3
Resistance
4.7KΩ

No results...

Learn to Add a Component

SN55HVD251 Reference Design

This is a reference design SN55HVD251 of with a standard configuration for normal mode #CANbus #SN55HVD251 #referenceDesign #canbus #texas-instruments #template #reference-design

Properties

creativecommons.org/licenses/by/4.0/

Pricing & Availability

Distributor

Qty 1

Digi-Key

$2.19–$4.58

LCSC

$5.18

Mouser

$3.58

Controls