PCB Outline Trace
Make the outline 50 mm wide by 60 mm tall, preserving the silhouette proportions from the photo.
Thought for 5 sec
I’ll trace a simplified closed dinosaur silhouette from the reference, scale it to exactly 50 mm × 60 mm, apply it as the PCB outline, and verify the resulting bounds.
Worked for 3 mins 4 sec
Created the dinosaur-shaped PCB outline from the photo at 50.01 mm × 60.00 mm with a 2-layer stackup. The 0.01 mm width difference is from outline-grid quantization.
- Open item: L1 and C1 are outside the new outline.
- Next: Move both components inside, then arrange and route them.
can u try again?
Thought for 6 sec
I’ll retry the outline with adjusted source coordinates to target an exact 50.00 mm × 60.00 mm applied bounding box, while preserving the dinosaur silhouette.
Worked for 1 min 10 sec
Updated and verified the dinosaur PCB outline at exactly 50.00 mm × 60.00 mm. The silhouette and 2-layer stackup are preserved; L1 and C1 remain unmoved.
Place components inside outline
Inspect board in 3D
Add mounting hole