PCB Design Help
Thought for 9 mins 16 sec
Thought for 5 sec
Referenced guidance.
Thought for 36 sec
Created a thread
FM Transmitter PCB Update
Needs input
View Thread
Thought for 6 sec
Awaiting 1 background task
"FM Transmitter PCB Update" completed.
Thought for 6 sec
The PCB-update work finished, but I could not retrieve and reconcile its detailed report or independently verify the resulting project state. I therefore cannot responsibly confirm that the microphone, SMA, and coil footprints were changed, rerouted, or included in refreshed exports.
Remaining verification:
- Confirm J2 is a direct-mount 5 × 6 mm electret footprint with polarity marking
- Confirm J3 is a 1.6 mm-board edge-launch SMA pattern with ANT_OUT center and grounded tabs
- Confirm L1 accepts formed 0.7 mm air-core coil leads
- Recheck board dimensions, zero airwires, and blocking DRC/ERC results
- Confirm assembly documents were updated
- Regenerate and verify manufacturing exports if needed
Execution stopped because your ACUs ran out.
Thought for 4 sec
I couldn’t perform or verify any additional work in this session. The reported microphone, edge-launch SMA, and air-core coil updates still need to be inspected, followed by DRC/ERC checks and regenerated manufacturing exports.
Execution stopped because your ACUs ran out.
Waiting for input
