Project Started
Thought for 13 sec
The audit confirms the board is electrically connected but not production-safe: USB has asymmetric vias and 3.4 mm skew, while XL1/XL2 have long multi-layer detours. I’m doing a controlled local rip-up—not another narrow patch—while preserving RF, U9, the outline, and all unrelated completed routing.
Thought for 15 mins 38 sec
The broad local re-layout is still running. It is rebuilding the USB corridor and crystal block together and restoring displaced nets; I’ll continue through an independent audit and exports once the live geometry passes.
Thought for 35 mins 41 sec
Received notification from "USB Crystal Layout" that it finished — picking the work back up.
Thought for 8 sec
The broad USB/crystal re-layout has settled. I’m reconciling the exact result now; if it passes, the next steps are BOM correction, independent release audit, and manufacturing exports.
Thought for 12 sec
The crystal block is now corrected, but the USB rebuild exposed a real pin-order crossover and left 13 airwires. I’m keeping the successful crystal work and resolving the crossover by reorienting U7 and restoring every displaced connection; exports remain blocked until the board returns to zero airwires.
Thought for 40 mins 33 sec
Received notification from "USB Crystal Layout" that it finished — picking the work back up.
Thought for 7 sec
This session established the actual release state and completed the crystal correction, but the board is not yet fab-ready.
- Independent audit confirmed the original USB route has four asymmetric through-vias, approximately 3.4 mm skew, variable geometry, and loose coupling. A fabrication impedance note cannot make that production-safe.
- The 32.768 kHz crystal block was rebuilt successfully: X1/C15/C16 placement and XL1/XL2 are now short, local, Top-only, and via-free.
- The USB rebuild exposed a D+/D− pin-order crossover between J1, U7, and U1. Reorienting U7 and restoring the displaced routes was launched, but I could not retrieve and independently reconcile its final report.
- The last confirmed intermediate state was commit #7214da2f with 13 airwires, so manufacturing exports were correctly withheld.
- BOM consolidation/mapping issues also still require correction before PCBA release.
Remaining release work:
- Confirm the latest live routing state and restore any remaining airwires.
- Complete USB as a Top-only, via-free, consistently coupled pair with ≤0.5 mm skew.
- Correct BOM grouping and remaining LCSC mappings.
- Run fresh independent ERC, DRC, route-layer, RF, footprint, and assembly audits.
- Generate and inspect Gerber/drill, BOM, and pick-and-place files.
Execution stopped because your ACUs ran out.
