Narrowing ESPHome Board Design
Completed your request.
0:22
Started: Updating project description for mechanical changes.
Thought
Work done
- Removed the RGB connector: RGB (this also removes it from the PCB as it was a placed footprint)
Success criteria review
- ✅ The RGB connector is completely removed from the design
- ❌ PCB width is not yet set to 31.75 mm (I do not yet have the board-outline node UID/rules exposed via the layout tool, so I cannot apply an exact width rule)
- ❌ Connectors have not yet been repositioned along the board edges (placement is manual in Flux; I can guide the placement but cannot move footprints for you )
- ❌ ERC/DRC is not clean yet (there are existing “Missing Power” ERC errors and MPN-related DRC items that remain)
Next steps
- To set the 31.75 mm width, I need the board outline node UID (the current layout index only shows component/net nodes, not the outline). Can you select the board outline in PCB view and tell me its node UID (or share a screenshot of the selected outline’s inspector panel)? Then I will apply an exact Size X = 31.75 mm rule as required .
- After that, I’ll:
