PCB Design Configuration
Configuring default trace widths...
0:09
Started: Set the default trace width for both top and bottom copper layers in the PCB layout rules.
Setting top copper layer width...
0:09
Started: Set default trace width for the top copper layer.
Creating VIN_RAW net class...
0:09
Started: Create a net class for VIN_RAW.
Thought
No changes were made to the PCB: all plan items remain undone.
Pending tasks
- Define net classes for VIN_RAW, VIN_PROTECTED, 1.0VV, 1.2VV, 1.8VV, 3V3, 5VV
- Assign each rail’s net (VIN_RAW, VIN_PROTECTED, 1.0VV, 1.2VV, 1.8VV, 3V3, 5VV) to its net class
- Configure default PCB rules:
- Trace widths (top & bottom)
- Clearance rules
- Via drill size and hole diameter for a 1.6 mm board
- Run Auto-Layout to place components and route all nets under the new rules
Tasks flagged as not automatable here
I’m unable to perform these actions directly; you’ll need to configure them in the Flux PCB editor.
Success criteria
None of the success criteria were met since no rules or net classes were created and no routing was performed.
Next step
Open your project in Flux, go to the PCB rules dialog to set the default widths, clearances, and via sizes, then define and assign the needed net classes before running auto-layout routing.
To get started, talk to Flux or create a New Document.
