Projects
Components
Guitar Pedal Template 88c3

Guitar Pedal Template 88c3

Guitar pedal starter template based on project by Mark Wu. Includes schematic and PCB layout for basic DIY pedal hardware. This includes two 1/4" jacks (one for input and one for output), a 9V power supply (including LED), a 3PDT true bypass wiring setup, and an example potentiometer that can be copy/pasted throughout the circuit. The headers are meant to be unpopulated so that wires can be soldered to the pads. PCB design rules imported from the JLCPCB 2-layer stackup template. #template
steven876543

steven876543

·

Custom Test Platform V1

Custom Test Platform V1

I want to create a standard interface from my PCBs to my test equipment. My equipment: PSU: Rigol DP832 Scope: Siglent SDS 1202X-E WaveGen: Siglent SDG810 Logic Analyzer: DSLogic Plus 400MHz VNA: NanoVNA V2 6 scope channels (4 1X, 2 10X) 8 Logic Analyzer channels 1 Wavegen channel 4 Power Nets ( 2 pins each) (tie power nets to oscilloscope inputs) #template #testing
steven876543

steven876543

·

Guitar Pedal Template

Guitar Pedal Template

Guitar pedal starter template based on project by Mark Wu. Includes schematic and PCB layout for basic DIY pedal hardware. This includes two 1/4" jacks (one for input and one for output), a 9V power supply (including LED), a 3PDT true bypass wiring setup, and an example potentiometer that can be copy/pasted throughout the circuit. The headers are meant to be unpopulated so that wires can be soldered to the pads. PCB design rules imported from the JLCPCB 2-layer stackup template. #template
steven876543

steven876543

·

Smart Button with E-Ink display

Smart Button with E-Ink display

This is a Smart Button project embedded with an E-Ink display. It uses an ESP32-PICO-KIT microcontroller and a Cherry MX mechanical switch for input detection. Upon the button press, various information is displayed on the E-Ink screen. #project #Template #projectTemplate
steven876543

steven876543

·