WiFi PC Power Switch Schematic
Thought for 2 mins 41 sec
Updated the PCB layout placement: added R3 10k pull-down, added 2 mounting holes, resized to 80 × 55 mm, placed ESP32/control side left, PC817 center, and J1 at the right board edge with left-to-right flow.
Open items:
- Routing is not completed because the autorouter is blocked by an active completed layout job in Flux.
- Airwires remain until routing can run.
- Pin mapping is verified correct: GPIO5 → R1 → PC817 AN, PC817 CAT → ESP32_GND, PC817 COL/EM → J1.
Suggested next steps:
- Clear/discard the active auto-layout job in the Flux UI, then ask me to route again.
- After routing, verify no traces cross the isolation corridor or ESP32 antenna area.
- Then run final DRC before fabrication export.
I cleared the layout job. Please run routing again.
Thought for 4 sec
I’ll rerun the routing pre-check, start autorouting, then verify remaining airwires and layout issues.
Thought for 23 sec
Routing pre-check passed: the board is valid and ready for autorouting.
Open items:
- I can’t start the autorouter now because your account currently has no available ACUs, so AI execution is paused.
- PCB traces are still not routed; airwires likely remain.
Suggested next steps:
- Add/restore ACUs, then ask me to “run autorouting again.”
- After routing, I’ll verify airwires, isolation gap, ESP32 antenna clearance, and terminal-side routing.
- Then we can run final DRC before fabrication export.
Manual routing check
Show airwires
Run DRC
Estimate ACUs
To get started, talk to Flux or create a New Document.
Welcome 👋
Flux helps you build PCBs faster with an AI teammate!
Create your account to collaborate, stay updated, fork your own version, and get instant answers from our AI agent.