MR30PW Part Audit
Thought for 8 sec
I’m validating the manufacturer drawing dimensions and pin numbering before making any metadata update.
Thought for 18 sec
Footprint geometry is captured: three 1.7 mm signal holes at 3.5 mm pitch plus two 1.0 mm mounting holes. I’m confirming these and the electrical ratings against the official source.
Worked for 5 mins 34 sec
Audit complete. Added the manufacturer-issued MR30PW-M datasheet to the part’s Datasheet URL property.
Key specs: 3-pin male right-angle THT connector, 3.5 mm pitch, 15 A rated/30 A momentary, 500 VDC, 0.80 mΩ contact resistance, −20°C to 120°C, PA UL94 V-0 housing, gold-plated brass contacts.
Flagged mismatches:
- Signal holes/pads are 1.7/2.55 mm, versus 1.9/3.0 mm in the referenced AMASS/KiCad footprint.
- Package metadata says “TO”, which is incorrect for this connector.
- Pin types and descriptions are unspecified; MH1/MH2 should be identified as mechanical mounting holes.
- The 3D asset is named
mr30pw-fb.step, suggesting the female variant is attached to this male part. - Description and electrical-rating properties are missing.
- The 3.5 mm contact pitch and mounting-hole positions match after accounting for footprint mirroring.
I filed an internal part-quality report; no footprint geometry was changed.
Correct part metadata
Fix footprint geometry
Replace 3D model
Prepare production check
