Pin Type Update for LMR38010SDDAR
Task: change only the pin electrical types of this LMR38010SDDAR part, then publish a new version
This part project (owner aaron0624) is used as U1 in the project aaron0624/isolated-uart-rs485-adapter. Do NOT change pin names, pin numbers, symbol layout, footprint, pads, 3D model or any other property. Only change the Pin Type property of these terminals:
Table
| Pin # | Name | New Pin Type |
|---|---|---|
| 1 | GND | Ground |
| 9 | EP | Ground |
| 7 | BOOT | Passive |
| 2 | EN | Passive |
| 4 | RT_SYNC | Passive |
| 5 | FB | Passive |
| 3 | VIN | Passive |
Leave pins 6 (PG) and 8 (SW) unchanged.
Steps:
- Read the symbol pins table and record current pin types.
- Edit the Pin Type property on the 7 terminals above.
- Re-read the pins table and confirm all 9 pins, names and numbers are unchanged and the 7 types are as listed.
- Publish a new part version with change notes: "Pin types only: GND/EP=Ground; BOOT/EN/RT_SYNC/FB/VIN=Passive. Footprint unchanged."
- Report the new published version ID, the before/after pin type table, and confirm the footprint was not touched.
Thought for 30 sec
Blocked: this session targets
silicon-yard/lmr38010sddar with view-only access, not the requested aaron0624-owned copy. I made no edits, did not publish, and did not touch the footprint.Current pin types: 1 GND=Ground; 2 EN=Input; 3 VIN=Power In; 4 RT_SYNC=Input; 5 FB=Input; 6 PG=Open Collector; 7 BOOT=Power In; 8 SW=Power Out; 9 EP=Ground. Please retarget this task to the editable aaron0624-owned part project.
Waiting for input
