Task: change only the pin electrical types of this LMR38010SDDAR part, then publish a new version
This part project (owner aaron0624) is used as U1 in the project aaron0624/isolated-uart-rs485-adapter. Do NOT change pin names, pin numbers, symbol layout, footprint, pads, 3D model or any other property. Only change the Pin Type property of these terminals:
Table
Pin #
Name
New Pin Type
1
GND
Ground
9
EP
Ground
7
BOOT
Passive
2
EN
Passive
4
RT_SYNC
Passive
5
FB
Passive
3
VIN
Passive
Leave pins 6 (PG) and 8 (SW) unchanged.
Steps:
Read the symbol pins table and record current pin types.
Edit the Pin Type property on the 7 terminals above.
Re-read the pins table and confirm all 9 pins, names and numbers are unchanged and the 7 types are as listed.
Publish a new part version with change notes: "Pin types only: GND/EP=Ground; BOOT/EN/RT_SYNC/FB/VIN=Passive. Footprint unchanged."
Report the new published version ID, the before/after pin type table, and confirm the footprint was not touched.
Blocked: this session targets silicon-yard/lmr38010sddar with view-only access, not the requested aaron0624-owned copy. I made no edits, did not publish, and did not touch the footprint.
Current pin types: 1 GND=Ground; 2 EN=Input; 3 VIN=Power In; 4 RT_SYNC=Input; 5 FB=Input; 6 PG=Open Collector; 7 BOOT=Power In; 8 SW=Power Out; 9 EP=Ground. Please retarget this task to the editable aaron0624-owned part project.
Power and analog ground terminal. Connect the VIN bypass capacitor directly between VIN and this pin using short, wide traces.
2
EN
Input
Regulator enable input. High enables operation and low disables operation. May connect directly to VIN; do not leave floating.
3
VIN
Power In
Top
Input supply to the regulator. Connect high-quality bypass capacitance directly to VIN and GND using short, wide traces.
4
RT_SYNC
Input
Switching-frequency programming resistor or external synchronization clock input. Connect a timing resistor to ground for frequency programming; do not leave floating or short directly to ground.
5
FB
Input
Regulator feedback input. Connect to the tap of the output-voltage feedback divider; do not leave floating or connect directly to ground.
6
PG
Open Collector
Open-drain power-good flag output. Pull up through a current-limiting resistor to a suitable supply. High indicates power good; low indicates power bad. May be left open when unused.
7
BOOT
Power In
Bootstrap supply for the internal high-side gate driver. Connect a high-quality 100 nF capacitor between BOOT and SW.
8
SW
Power Out
Regulator switching node. Connect to the power inductor and the BOOT capacitor return; keep the copper area compact.
9
EP
Ground
Bottom
Exposed thermal PowerPAD. Solder to the PCB thermal land and connect to system ground.