EG915U Pin Audit
Thought for 12 sec
Understood — I’ll extend the audit into a direct symbol-property update only, preserving every existing pin number/name and assigning Section, Pin Orientation, and Terminal Order from the datasheet rules.
Worked for 3 mins 35 sec
Core signal pins are assigned; I’m applying the NC/reserved and ground ordering now, keeping grounds last.
Worked for 4 mins 4 sec
Created a project doc
Completed: audited the Quectel EG915U part, preserved all existing pin numbers/names, and assigned
Pin Orientation, Section, and Terminal Order across all 126 terminals; power pins are first and GND pins are last. I also created the detailed review here: EG915U Part Audit and Pin Assignment.Open items:
- Datasheet URL was already set, so I did not replace it with a newer official Quectel link.
- Pin descriptions and Pin Type remain unchanged per your “only assign properties” constraint.
- Footprint has 126 pads, but geometry should be dimension-checked against the official land pattern before release.
Suggested next steps:
- Normalize cosmetic terminal names like
USB_BOOT_,USIM1_VDD_, andANT_BT/WIFI__SCAN. - Populate Pin Description and Pin Type from the datasheet.
- Verify the footprint dimensions against the latest official Quectel hardware design PDF.
Normalize, populate, verify
Normalize terminal names
Populate pin metadata
Verify footprint geometry
Run ERC DRC
