I’ll check the board’s routing readiness, then run autorouting and review the result for remaining airwires or DRC issues.

The board is valid, but the router reports the default trace width is larger than the connector pad size. I’m tightening the routing rules for this fine-pitch breakout before routing.

I updated the fine-pitch routing constraints. The second preflight check timed out, so I’m proceeding with the autorouter and will validate the result afterward.

Blocked by a platform rate-limit error while starting the autorouter.

I did complete the prep work: the board is valid, and I updated the fine-pitch routing constraints to 0.10 mm traces with 0.05 mm pad clearance so the OK-118 connector pads are routable. The routing job itself failed to start with a 429 network error; I reported it internally. Current state still has the routing step pending.