I’ll verify the existing pushbuttons and ensure both ESP32-S3 processors can be put into download mode and reset reliably. If the controls are incomplete, I’ll correct the schematic and rerun the electrical review.

The two existing buttons are currently disconnected. Because the two ESP32s use isolated power domains, they cannot safely share direct BOOT or RESET switches; I’m adding independent BOOT and RESET controls for each processor so either firmware image can be flashed without backfeeding the other side.

Added independent RESET and BOOT/FLASH buttons for both ESP32-S3 processors:

The isolated power domains remain separate, and the schematic review reports no electrical errors or warnings.

Removed the OLED screen (OLED1) from the schematic and PCB.

Fixed. The USB-A connector now faces outward, while remaining centered between the two USB-C connectors.