Getting Started with Flux
Thought for 2 mins 50 sec
Thought for 7 sec
Awaiting 1 task
"Four-Channel ESC Schematic" completed.
Thought for 11 mins 14 sec
Thought for 11 sec
Reading schematic details of Four-Channel 55A ESC Prototype.
Thought for 7 sec
Reading project docs of Four-Channel 55A ESC Prototype.
Thought for 8 sec
Awaiting 1 task
"Flight Controller Schematic Prototype" completed.
Thought for 6 sec
I started two separate projects and recorded the original unequal-size requirements.
- FC project: latest saved state has 36 components and 27 nets, including STM32F405, ICM-42688-P gyro, 16MB flash, USB-C, USB protection, clock oscillator and 3.3V regulator parts. Electrical capture progressed, but I haven’t completed the final connectivity, power and firmware-compatibility review. The 39 × 39mm size is recorded—not yet implemented as a finished PCB layout.
- ESC project: 4 components and 3 nets form a provisional battery-voltage divider/filter and TVS branch. The unloaded divider was simulated; inspection found 0 ERC errors and 1 warning. This is not yet a working motor ESC.
Still unresolved: actual ESC bare-board geometry within the published 40.9 × 44.9mm heatsink-inclusive envelope, exact ten-pin cable mapping, and verified OX32 controller/firmware access. Motor power stages, matching pad positions/silkscreen, PCB routing and 55A load/thermal validation remain unfinished; neither board is manufacturing-ready or an exact verified copy.
Execution stopped because your ACUs ran out.
Waiting for input
