This is an ESP32-C3 reference design based on the manufacturer's recommendations with a uFL SMD antenna and USB C on board #WiFi #ESP32-C3 #IoT #referenceDesign #simple-embedded #espressif #template #reference-design

This is an ESP32-C3 reference design based on the manufacturer's recommendations with a uFL SMD antenna and USB C on board #WiFi #ESP32-C3 #IoT #referenceDesign #simple-embedded #espressif #template #reference-design

This is an ESP32-C3 reference design based on the manufacturer's recommendations with a uFL SMD antenna and USB C on board #WiFi #ESP32-C3 #IoT #referenceDesign #simple-embedded #espressif #template #reference-design

4-layer marine GPS timing and communication device using nRF52840, u-blox ZED-F9P GNSS with external active antenna via u.FL, 915 MHz LoRa radio, Li-ion battery with USB-C charging, separate clean GNSS LDO and digital 3.3V rail, SPI memory LCD, RGB LEDs, buzzer, and 6-axis IMU. PCB target is a 70 mm circular layout with strict RF zoning, dedicated ground plane, 50 ohm RF traces, physical separation between GNSS and LoRa, and low-noise placement suitable for harsh marine environments.

XIAO-Compatible 915MHz RF Shield with Wio-LR1121 Module and u.FL Interface

Ultra-Compact 4-Layer ESP32-C6 + Quectel EG912U LTE Dev Board w/ Onboard eSIM, π-Match RF Tuning, Optional u.FL, USB-C Data (ESP32-C6 Only), USB-C Battery Charging, Controlled Impedance Routing #EG912U #USBDataOnly #USBCharging #4Layer #eSIM

This is an ESP32-C3 reference design based on the manufacturer's recommendations with a uFL SMD antenna and USB C on board #WiFi #ESP32-C3 #IoT #referenceDesign #simple-embedded #espressif #template #reference-design

This is an ESP32-C3 reference design based on the manufacturer's recommendations with a uFL SMD antenna and USB C on board #WiFi #ESP32-C3 #IoT #referenceDesign #simple-embedded #espressif #template #reference-design

Compact 2-Layer ESP32-WROOM-32E Ultrasonic Emitter Board with USB-C Auto-Programming, On-Board 12 V→3.3 V Buck, 3× Low-Side MOSFET Drivers, Optional U.FL Antenna, ESD/TVS Protection, RF/Power Partitioning, and Named Nets (PWR_12V_IN, 3V3, GND, DRV_CH1/2/3, LED_PWR/LED_NET/LED_EMIT) #ultrasonic #ESP32 #RFDesign #PowerDesign #PCBDesign

This is a compact, high-performance RFID antenna solution built on a printed circuit board configurations. It has miniature RF connector (also known as a U.FL or IPX connector) that allows easy connection to an external antenna. It’s especially useful when you want better signal performance or need to position the antenna away from the main board (e.g., in an enclosure or plastic housing).