Bluetooth RC car controller using ESP32-WROOM-32E, TB6612FNG dual H-bridge, XL4015 5V buck module, DC barrel battery input, dual 2-pin motor screw terminals, 1000uF VM bulk capacitor, 100nF decoupling, 10k EN pull-up, 30 mil power traces, 10 mil signal traces, and ESP32 antenna edge keep-out.

This tiny board is an easy way to use Toshiba’s TB6612FNG dual motor driver, which can independently control two bidirectional DC motors or one bipolar stepper motor. A recommended motor voltage of 4.5 V to 13.5 V and peak current output of 3 A per channel (1 A continuous) make this a great motor driver for low-power motors. #Module #Motor-Driver #TB6612FNG

This tiny board is an easy way to use Toshiba’s TB6612FNG dual motor driver, which can independently control two bidirectional DC motors or one bipolar stepper motor. A recommended motor voltage of 4.5 V to 13.5 V and peak current output of 3 A per channel (1 A continuous) make this a great motor driver for low-power motors. #Module #Motor-Driver #TB6612FNG

Carrier PCB schematic for a four-wheel Arduino Nano ESP32 spy car using two TB6612FNG motor-driver modules, removable Nano sockets, servo/sensor/light/buzzer connectors, and protected shared battery power. PCB layout is intentionally deferred pending module dimensions and electrical ratings.

Raspberry Pi 4 based AI robot car with camera, four encoder motors, dual TB6612FNG drivers, ToF/ultrasonic/IMU sensors, PCA9685 servo control, and 2S LiPo power through emergency and main switches.

ESP32-based motor controller using a buck converter and SparkFun TB6612FNG motor driver, with a 2-terminal DC motor placeholder for the JGA25-371 gearmotor.

Compact ESP32-S3 AI robot controller with DevKitC-1 module, 2S Li-ion power input, 5V buck regulator, optional clean 3.3V rail, TB6612FNG dual motor driver, OV2640 camera FPC, I2S audio, OLED, ultrasonic and TCRT5000 sensor headers, and a compact 2-layer PCB prepared for Gerber export.

T-Shaped Raspberry Pi Pico 2 Motor-Control PCB with TB6612FNG, LM2596, and MPU-6050

quiero conecatr un arduino nano con un driver tb6612fng