NAND programmer based on STM32 processor. It supports parallel NAND and SPI flash programming.

ESP32-C6-DevKitM-1 is an entry-level development board based on ESP32-C6-MINI-1(U), a general-purpose module with a 4 MB SPI flash. This board integrates complete Wi-Fi, Bluetooth LE, Zigbee, and Thread functions.

IC FLASH 256MBIT SPI

RP2040 is a low-cost, high-performance microcontroller device with flexible digital interfaces. Key features: • Dual Cortex M0+ processor cores, up to 133 MHz • 264 kB of embedded SRAM in 6 banks • 30 multifunction GPIO • 6 dedicated IO for SPI Flash (supporting XIP) • Dedicated hardware for commonly used peripherals • Programmable IO for extended peripheral support • 4 channel ADC with internal temperature sensor, 0.5 MSa/s, 12-bit conversion • USB 1.1 Host/Device

ESP12F IoT Node with SIM800L Cellular, MT3608/AMS1117 Power, SPI Flash, I2S Audio, USB-C UART, and Li-Ion Management

Picotag is a JTAG/SWD interface interrogator and SPI flash firmware dumper based off the Bluetag firmware. #raspberry #pi #pico #bluetag

Production-defensible Rev B ear tag tracker using nRF9151 with separate LTE and GNSS antennas, solar-assisted LiPo charging, battery protection, SPI NOR flash, NFC, eSIM, I2C sensors, Tag-Connect SWD, grouped EVT test points, and RF/power zoning on a 40 mm x 24 mm 4-layer PCB.

The Atmel® | SMART SAM9260, manufactured by Atmel, is an ARM-based Embedded Microprocessor Unit (MPU), integrating the ARM926EJ-STM processor operating at 180 MHz. This MPU includes substantial on-chip memory and extensive peripherals, including an Ethernet MAC, USB Device and Host Ports, along with various standard interfaces such as USART, SPI, TWI, Timer Counters, and MultiMedia Card Interface. Architected on a 6-layer matrix delivering a maximum internal bandwidth of six 32-bit buses, it supports external 32-bit bus interfaces for SDRAM, static memories, CompactFlash, and SLC NAND Flash with ECC. The SAM9260 is available in 217-ball LFBGA and 208-pin PQFP packages. Key features include 8 Kbytes each of data and instruction cache, integrated MMU, two internal 4-Kbyte SRAMs, a 32-Kbyte ROM with bootloader, 22 Peripheral DMA channels, various power-on reset modes, two programmable clock signals, advanced interrupt controller, and multiple power management options for optimized performance and energy efficiency.