Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Welcome to your new project. Imagine what you can build here.

Lethal Company Pro Flashlight Broken Features: - U2M cannot be line powered from this circuit so the LED driver does not regulate. [Find the acompanying button board here](https://www.flux.ai/markwuflux/lethal-company-pro-flashlight-button-board) -Ultra bright -Makes click noise from speaker -Wirelessly transmits battery life (maybe use Ubo to receive this) -Drive a SST-40 Chinese LED I want this thing to be super bright! The brighter the better, but keep it simple. These LEDs will draw a lot of power, so we need some sort of CC source. It doesn't have to have high bandwidth. I am thinking about a DIY microcontroller buck converter with PID duty cycle control. Mistakes in this V1 design: - No pullup resistor on PG of Module1

A simple voltage divider to showcase how to make parts. A voltage divider is a simple circuit which turns a large voltage into a smaller one. Using just two series resistors and an input voltage, we can create an output voltage that is a fraction of the input. Voltage dividers are one of the most fundamental circuits in electronics.

This is a simple Bridge Rectifier project using 4 rectifying diodes and 2 filtering capacitors #BridgeRectifier #rectifier #AC #DC #project

A simple fixed linear voltage regulator board that can provide 3.3V up to 1A output and could operate down to 1V input-to-output differential. #firstpcbFlux

TinyCandle is a simple tealight candle simulation based on the ATtiny13A.

Simple Ethernet board used WIZ550 with real MAC address and configures the network setting automatically.

Simple UPDI programmer for tinyAVR, megaAVR and AVR-Dx microcontrollers with voltage selection switch (5V and 3.3V).

A simple pre-amplifier circuit based on two transistors

A simple fixed linear voltage regulator board that can provide 3.3V up to 1A output and could operate down to 1V input-to-output differential. #firstpcbFlux

This simple board is based on SN74HC595 capable of controlling 8 relays serially.

A simple voltage divider to showcase how to make parts. A voltage divider is a simple circuit which turns a large voltage into a smaller one. Using just two series resistors and an input voltage, we can create an output voltage that is a fraction of the input. Voltage dividers are one of the most fundamental circuits in electronics.

A simple walkie-talkie circuit running off an Arduino Nano. Utilizes a BJT to amplify the microphone voltage and transmits the radio signal through a nRF24L01 series Transceiver.

ifusb is a simple toolkit to access GPIO/UART/SPI/I2C from USB host through microcontroller. It was initialy attended for use with eink controller project, but can be used as a tool for any project, like a Bus Pirate board or a FT2232 chip.

ATmega16/32 Development Board provides a very simple and cost effective platform for prototyping solution. The compact design provides connection to all the pins of the microcontroller for the user.

A simple parallel circuit with two resistors in parallel and a DC power source.

A simple fixed linear voltage regulator board that can provide 3.3V up to 1A output and could operate down to 1V input-to-output differential. #firstpcbFlux

Welcome to your new project. Imagine what you can build here.