USB-C Environmental Sensor Node
Thought for 3 sec
flux
- Set Layout's boardColor to "Purple"
- Set Layout's boardInsetMargin to "0.5mm"
- Set Layout's keepOut to "0.2mm"
- Set Layout's traceWidth to "0.25mm"
- Set Layout's minTraceWidth to "0.2mm"
- Set Layout's traceCornerRadius to "0.3mm"
Task unable to complete.
3:24
Checking 5 design areas.
Started: verifying U1 placement and restoring symmetric field.
Search "Which switches and diodes were removed from the or...".
Reading schematic details for U1.
Search project.
Search project.
Thought for 6 sec — Clarifying key count confusion
Thought for 8 sec
flux
Work done
- Set the layout to 150 mm x 100 mm landscape with 4 mm rounded corners and kept the 4-layer stackup.
- Added four corner mounting holes: H1, H2, H3, and H4.
- Applied the requested purple board finish and rechecked layout/ERC state.
- Verified the current keyboard state: 44 switches and 44 diodes remain,
ROW7_AUXstill exists in the project, and the matrix is still incomplete.
Success criteria review
- ✅ Board dimensions are now 150 mm x 100 mm in landscape orientation.
- ❌ The top-edge USB-C is not yet centered/aligned with U1; U1 is still offset in the layout.
- ✅ Corner mounting holes were added.
- ❌ The symmetric key field is not restored; the project still has 44 keys instead of the intended restored field.
- ✅ Purple finish was applied.
- ❌ Final ERC/DRC is not clean: there are 170 airwires and 11 floating pins on U1.
Next steps
I completed the mechanical baseline, but I cannot finish the remaining plan in this run because the available actions here do not include the required PCB component placement tool needed to accurately move U1, place the mounting holes into their final corner coordinates, and restore the symmetric key field in the layout before matrix cleanup. If that placement capability is made available, the next pass should: center U1 on the top edge USB datum, restore the missing top-row keys to reach the intended 50-key field, remove
I completed the mechanical baseline, but I cannot finish the remaining plan in this run because the available actions here do not include the required PCB component placement tool needed to accurately move U1, place the mounting holes into their final corner coordinates, and restore the symmetric key field in the layout before matrix cleanup. If that placement capability is made available, the next pass should: center U1 on the top edge USB datum, restore the missing top-row keys to reach the intended 50-key field, remove
ROW7_AUX, reconnect the matrix, then clear the remaining ERC/DRC issues.Add USB protection
Specify mount hole size
Set key spacing
Waiting for input
