Created the complete ESP32-S3 OLED watch schematic with USB-C, 200mA LiPo power-path charging, 3.3V buck-boost regulation, BMI270 IMU, MAX17048 fuel gauge, OLED, and five buttons. All 52 components and 30 nets are electrically verified with zero ERC errors and no wire/symbol collisions.
Open items
PCB dimensions, battery size, enclosure, and final OLED mechanical geometry must be defined before layout.
R7 is DNP when using a battery with a 10kΩ NTC; populate it for a two-wire battery.
I’ll reorganize the schematic into clearly separated functional blocks, preserve every connection and value, then re-run electrical and geometry checks.
Arranged all 52 schematic components into distinct functional groups: USB/protection, LiPo charging, buck-boost supply, ESP32-S3, I²C peripherals, OLED, and user controls. Connectivity is unchanged, with zero ERC errors, wire collisions, symbol collisions, or label collisions.
Open items
15 cosmetic lint warnings remain: three unavoidable pin-alignment kinks, two cross-group resistor-bank warnings, and duplicated distant-ground warnings for the isolated USB block.
Suggested next steps
Define watch PCB dimensions and display/battery geometry.
Start four-layer PCB placement with the ESP32 antenna keepout.
USB input and charge-current limits are approximately 500mA and 200mA respectively.
Assumptions
OLED is monochrome 128x64 and operates at 3.3V over I2C.
Battery is protected and at least 400mAh.
No speaker, haptic motor, microphone, GPS, or health sensors are included.
No touch screen is included; user interaction uses three buttons.
Final mechanical dimensions are intentionally deferred to the PCB-layout checkpoint.
Change Notes
Initial architecture established from the request for ESP32-S3, OLED, LiPo charging, and accelerometer.
Completed library-sourced schematic with USB-C protection/native USB, charger power path, 3.3V buck-boost, MCU support, shared I2C peripherals, and five buttons.