ASCOM Mount Dither
Worked for 2 mins 1 sec
The review package is updated. I’m also refreshing the project specification to match the corrected PhotoMOS/SPST revision.
Worked for 1 min 4 sec
The project specification is refreshed to the corrected PhotoMOS version. I’m verifying the final file list and marking the revision complete.
Worked for 28 sec
Final ERC/BOM/schematic checks are clean; no PCB placement/routing was started.
Thought for 21 sec
Implemented the schematic-only V1 revision: replaced the TLP291-4 with four TLP171A(TP,F) PhotoMOS relays, replaced SW1 with a true SPST ON/OFF switch, preserved the V2 archive, and updated the review docs.
Updated files:
Open items:
- No PCB placement/routing was started.
- J1 pin-1 marker and “ST-4 - STRAIGHT 1:1 6P6C ONLY” silkscreen note remain layout-stage tasks.
- Board outline, connector access, battery-holder position, and mounting method still need definition before placement.
Suggested next steps:
- Review/approve the corrected PhotoMOS schematic and BOM.
- Confirm SW1 = DS04-254-2-01BK-SMT is acceptable as the physical power switch.
- Confirm whether J2 should stay as a 1x03 UPDI header or change to test pads before layout.
Approve and prepare layout
Approve PhotoMOS schematic
Keep UPDI header
Define board outline
Verify RJ12 footprint
Review switch choice
