A Blinking LED
Worked for 1 min 37 sec
The schematic is now wired. I’m verifying the netlist and ERC checks, including the 555 mandatory reset, control bypass, and supply decoupling connections.
Worked for 2 mins 59 sec
Implemented the 9V hand-solderable red LED blinker schematic using a TI NE555P DIP-8, through-hole LED, slide switch, PP3 9V battery holder, axial resistors, and through-hole capacitors. The 555 astable is set to about 1.06 Hz with ~50% duty cycle, so the LED blinks roughly once per second; electrical connectivity checks are clean.
Open items:
- PCB layout/routing is not done yet, so airwire DRC errors are expected.
- Generic passives have through-hole packages and values, but not exact manufacturer part numbers yet.
Suggested next steps:
- Assign exact MPNs for the generic resistors/capacitors if you want a manufacturable BOM.
- Move into PCB layout: size the board, place the battery holder/switch/LED, then route.
- Add silkscreen labels for battery polarity, switch ON/OFF, and LED orientation.
BOM and layout
Assign passive MPNs
Start PCB layout
Route the board
Add silkscreen labels
Demo Complete
The demo is finished. It didn't use any ACUs. You can now continue working with this project like normal.
