Project Brainstorming Questions
Thought for 39 sec
Below is a summary of your design and an initial block diagram based on your responses:
System Overview
You are designing a circuit that accepts a 12V, GND, and a 2 kHz PWM signal. These inputs pass through an RC low-pass filter to smooth the PWM into a variable DC voltage. That voltage is then used to drive the output stage, which features a MOSFET Driver that actively controls the DC brushless fan. Additionally, you want to incorporate overcurrent and reverse-polarity protection (using components such as current-limiting resistors and diodes).
Block Diagram
Diagram
Components List
Table
| Component | Function | Suggested Part / Comments |
|---|---|---|
| Input Source | Supplies PWM signal at 2 kHz | Provided externally |
| DC Supply | 12V power input | External 12V source |
| RC Lowpass Filter | Smooths the 2 kHz PWM into a DC level | Use appropriately chosen resistor and capacitor (e.g., R1 and C1) -- R1 / C1 |
| MOSFET Driver | Acts as a voltage-controlled switch for the fan | IRLZ44N (logic-level MOSFET) |
| Protection Diode | Provides reverse-polarity protection (Schottky) | 1N5819 |
| Current-Limiting Resistor | Limits inrush/current peaks to protect the circuit | R2 (value to be calculated by design) |
| DC Brushless Fan | The load whose speed is controlled | Refer to datasheet: D08090300G-00 |
Next Steps
Your next step is to finalize the component values for the RC low-pass filter and the current-limiting resistor, ensuring they meet the technical requirements of your fan and the driving stages. Feel free to ask for further assistance on component calculation or any additional design details!
Calculate RC values
Select MOSFET model
Specify protection components
No schematic yet
Talk to Flux to get started.
