Linear Issues Review
Thought for 1 min 51 sec
flux
Done. I focused the local reroute-prep rules on the hotspot cluster using the direct layout/review workflow: inspect with real-time project tools first, then apply targeted layout-rule changes rather than broad guesses
Updated local rules
Table
| Area | Change |
|---|---|
| J2 | keep out / min keep out -> 0.15 mm, local trace width -> 0.15 mm, local via size -> 0.45 mm, via hole -> 0.20 mm |
| U5 | keep out / min keep out -> 0.15 mm, local trace width -> 0.20 mm, local via size -> 0.45 mm, via hole -> 0.20 mm |
| KEY1 | keep out / min keep out -> 0.15 mm, local trace width -> 0.15 mm |
| KEY2 | keep out / min keep out -> 0.15 mm, local trace width -> 0.15 mm |
| KEY3 | keep out / min keep out -> 0.15 mm, local trace width -> 0.15 mm |
| KEY4 | keep out / min keep out -> 0.15 mm, local trace width -> 0.15 mm |
| KEY5 | keep out / min keep out -> 0.15 mm, local trace width -> 0.15 mm |
The hotspot prep is in place, but the board is still blocked mainly by existing unrouted/conflicting copper:
- 96 airwires
- 9 overlapping copper
- 0 floating copper in the latest check
- J2 now has friendlier local escape-routing rules for the 0.5 mm FFC area.
- U5 keeps a slightly wider local trace rule than the buttons.
- The button cluster KEY1 to KEY5 is now loosened consistently for future rerouting.
If you want, I can next:
Review priority nets
Separate U5 backlight
Check overlap hotspots
Thought for 2 sec
flux
- Set J2's minKeepOut to "0.15mm"
- Set J2's keepOut to "0.15mm"
- Set J2's traceWidth to "0.15mm"
- Set J2's size to "0.45mm"
- Set J2's holeSize to "0.20mm"
- Set U5's minKeepOut to "0.15mm"
- Set U5's keepOut to "0.15mm"
- Set U5's traceWidth to "0.20mm"
- Set U5's size to "0.45mm"
- Set U5's holeSize to "0.20mm"
- Set KEY1's minKeepOut to "0.15mm"
- Set KEY1's keepOut to "0.15mm"
- Set KEY1's traceWidth to "0.15mm"
- Set KEY5's minKeepOut to "0.15mm"
- Set KEY5's keepOut to "0.15mm"
- Set KEY5's traceWidth to "0.15mm"
- Set KEY3's minKeepOut to "0.15mm"
- Set KEY3's keepOut to "0.15mm"
- Set KEY3's traceWidth to "0.15mm"
- Set KEY4's minKeepOut to "0.15mm"
- Set KEY4's keepOut to "0.15mm"
- Set KEY4's traceWidth to "0.15mm"
Thought for 4 sec
flux
- Set KEY2's minKeepOut to "0.15mm"
- Set KEY2's keepOut to "0.15mm"
- Set KEY2's traceWidth to "0.15mm"
