ESP-WROOM-02D Reference Design
This project is a reference design for an ESP-WROOM-02D based device. It features USB-C for power and data transfer, onboard voltage regulation, and multiple peripheral connections. It also...
Projects
Components
Arduino Uno R3 Shield Max485 single
Template for Arduino Uno R3 Shield. Include an official pinout so you will always know Arduino names, the alternative roles of pins, which one is SDA, or SCL, etc. On PCB you can find the 3D model of...
Featherwing template for nRF52 Bluefruit
Featherwing template with pre-loaded nRF52 Bluefruit feather. #template #feather #wing #adafruit
ESP-CAM Motherboard Module
This project is a motherboard for the ESP32-CAM module, which enables easy and flexible WiFi camera applications. The motherboard provides power supply, programming interface, and GPIO...
Arduino ATMEGA328P-MU Template 1Gym
Arduino Template based on ATMEGA328P-MU. This MCU is used in Arduino UNO Rev. 3, Arduino Nano V3.0, and some other. This template is a good starting point for your Arduino based...
Pulse Width Modulation (PWM) Controller 7eNk
This project is a Pulse Width Modulation (PWM) Controller, built around an LM555 timer IC. It controls a load connected to a MOSFET, with adjustments via a potentiometer, and uses capacitors,...
ESP32-S3-WROOM-1 Reference...
This project is a reference project for ESP32-S3-WROOM-1 to develop your IoT ideas. The board has 3 LEDs, USB C for firmware, EN and BOOT buttons, and 2 IO connectors for development
#IoT...
ESP32-S3-WROOM-1 Reference Design rt4s
This project is a reference project for ESP32-S3-WROOM-1 to develop your IoT ideas. The board has 3 LEDs, USB C for firmware, EN and BOOT buttons, and 2 IO connectors for development
#IoT...
1 Fork
ESP32-S3-WROOM-1 Reference Design kyJm
This project is a reference project for ESP32-S3-WROOM-1 to develop your IoT ideas. The board has 3 LEDs, USB C for firmware, EN and BOOT buttons, and 2 IO connectors for development
#IoT...
ESP32-S3-WROOM-1 Reference Design 52mu
This project is a reference project for ESP32-S3-WROOM-1 to develop your IoT ideas. The board has 3 LEDs, USB C for firmware, EN and BOOT buttons, and 2 IO connectors for development
#IoT...