Edge13 Schematic Review
Thought for 3 sec
The PCB Placement Pass was already reconciled against the live board; no additional project changes were made this session.
Verified state:
- All 134 footprints are placed: 81 top / 53 bottom
- J3 USB-C:
(27, −32.9) mm, bottom edge - J4 USB-A:
(44.72, −21) mm, right edge - J5 USB-B:
(−44.5, −21) mm, left edge - BT1: provisional bottom-side placement at
(0, 2) mm - J1/J2 remain locked at
(±17, 12.5) mm, 90° rotation, preserving the official 34 mm CM5 spacing - Board remains 110 × 75 mm, four copper layers
- No reported component-body overlaps or out-of-bounds footprints
- No routed traces exist; 285 airwires remain
- The 18 pre-existing legacy GND via nodes remain
Remaining issues:
- BT1’s 94.6 × 26 mm body conflicts with the fixed CM5/antenna region. Its position cannot be accepted until enclosure and vertical-clearance geometry are resolved.
- D3 retains a library/differential-pair warning that must be reviewed before USB routing.
- Routing congestion is expected near J1, U5, R17, R18, and TP11.
- Connector plug/enclosure clearance has been planned geometrically but still requires enclosure-level validation.
Execution stopped because your ACUs ran out.
Received notification from "PCB Placement Pass" that it finished — picking the work back up.
Thought for 5 sec
The PCB Placement Pass was already fully reconciled against the live board. This is a duplicate completion notification, so no further changes were made.
Placement is complete; remaining unresolved items are the provisional BT1/CM5 mechanical conflict, the D3 USB warning, and enclosure-level connector clearance validation. No routing or schematic changes were performed.
Thought for 3 sec
Stopped. No further project changes will be made.
Received notification from "PCB Placement Pass" that it finished — picking the work back up.
Thought for 5 sec
This is a duplicate completion notification. The placement pass was already reconciled, and the user subsequently ordered all work stopped. No further inspection, placement, routing, or project changes were performed.
