Creating Ground Plane Setup
Thought
Work completed
- Project description updated to “This project unifies all ground connections across the schematic and PCB by consolidating every ground pin into a single, canonical Ground net and creating an automatic copper ground plane with thermal reliefs to ensure robust connectivity and solderability. #groundplane #schematic #pcb”
- Added the canonical Ground symbol to the schematic
- Severed all former ground pin connections (J1:GND, IC1:GND, D1:K, C1:P2, BZ1:-) and reconnected them to the unified Ground net
- Removed all non-canonical ground portal components
- Fetched the airwire DRC review and updated the “Ground Airwire Check” project property
- Messaged the “Ground Airwire Check” results to you
Not performed
- Creating and saving a Mermaid flowchart of the Ground net in project properties
- Assigning the Ground net to an automatic copper fill on PCB layers
- Configuring thermal relief settings for Ground pads
- Regenerating the copper fills for the ground plane
- Fetching schematic connections for net “GND” and messaging the “Ground Connectivity” results
Success criteria review
- ✅ All ground pins and pads on the schematic are tied to the canonical Ground net
- ❌ PCB ground plane with thermal reliefs not yet applied; ground-plane connectivity checks remain unverified
Next, I recommend updating the PCB layout by assigning the unified Ground net to an automatic copper fill, configuring thermal reliefs on all Ground-connected pads, regenerating the copper fills, and then rerunning the airwire check to confirm complete ground connectivity.
