Work completed
- Project description updated to “ESP32-C3 Super-Mini IoT Light & Environmental Monitor with TEMT6000 (ADC) and BME680 (I2C)”
- System Architecture property set and diagram sent
- Added U2 and U3 to the schematic
- Added two 4.7 kΩ pull-up resistors (R1, R2) on SDA/SCL
- Added RC filter (10 kΩ resistor R3 + 100 nF capacitor C1) on TEMT6000 analog output
- Wired VCC/GND and SDA/SCL nets for BME680
- Wired VCC/GND, AO net, and RC filter for TEMT6000
- Reviewed schematic for completeness
Tasks pending (cannot be done here)
- Sync schematic changes to PCB layout
- Place BME680 and TEMT6000 footprints on PCB
- Run DRC and review connectivity errors
Success criteria
- ✔ Breakouts added with correct wiring and pull-ups
- ✔ RC filter applied to TEMT6000 output
- ✖ Footprints not yet placed
- ✖ DRC not yet run
Next step
Please sync the schematic to the PCB layout so I can place the footprints and run DRC to complete the design.